Geeetech: Add E180, clean up A30 (#16072)

config/examples/Geeetech/A30/Configuration.h

@@ -476,7 +476,7 @@
   // If you are using a pre-configured hotend then you can use one of the value sets by uncommenting it
 
   //FIND YOUR OWN: "M303 C8 S200 U" HOTEND PID
-  
+
   #define  DEFAULT_Kp 45.80
   #define  DEFAULT_Ki 3.61
   #define  DEFAULT_Kd 145.39
@@ -515,7 +515,7 @@
 #if ENABLED(PIDTEMPBED)
   //#define MIN_BED_POWER 0
   //#define PID_BED_DEBUG // Sends debug data to the serial port.
-  
+
   #define  DEFAULT_bedKp 369.610
   #define  DEFAULT_bedKi 54.132
   #define  DEFAULT_bedKd 602.870
@@ -1087,7 +1087,7 @@
 #if ENABLED(FILAMENT_RUNOUT_SENSOR)
   #define NUM_RUNOUT_SENSORS   1     // Number of sensors, up to one per extruder. Define a FIL_RUNOUT#_PIN for each.
   #define FIL_RUNOUT_PIN      66
-  #define FIL_RUNOUT_INVERTING true  // set to true to invert the logic of the sensors. - some of the geeetech filament sensors are false 
+  #define FIL_RUNOUT_INVERTING true  // set to true to invert the logic of the sensors. - some of the geeetech filament sensors are false
   #define FIL_RUNOUT_PULLUP          // Use internal pullup for filament runout pins.
   //#define FIL_RUNOUT_PULLDOWN      // Use internal pulldown for filament runout pins.
 
@@ -1603,6 +1603,7 @@
  *
  */
 #define SDSUPPORT
+#define SDIO_SUPPORT
 
 /**
  * SD CARD: SPI SPEED
@@ -1682,7 +1683,7 @@
 //
 // Add individual axis homing items (Home X, Home Y, and Home Z) to the LCD menu.
 //
-#define INDIVIDUAL_AXIS_HOMING_MENU //free
+#define INDIVIDUAL_AXIS_HOMING_MENU
 
 //
 // SPEAKER/BUZZER
@@ -2072,7 +2073,7 @@
 // Use software PWM to drive the fan, as for the heaters. This uses a very low frequency
 // which is not as annoying as with the hardware PWM. On the other hand, if this frequency
 // is too low, you should also increment SOFT_PWM_SCALE.
-#define FAN_SOFT_PWM //costs 2b //enables parts fan speed control
+#define FAN_SOFT_PWM
 
 // Incrementing this by 1 will double the software PWM frequency,
 // affecting heaters, and the fan if FAN_SOFT_PWM is enabled.

config/examples/Geeetech/A30/Configuration_adv.h

@@ -1722,7 +1722,7 @@
  * Requires NOZZLE_PARK_FEATURE.
  * This feature is required for the default FILAMENT_RUNOUT_SCRIPT.
  */
-//#define ADVANCED_PAUSE_FEATURE 
+//#define ADVANCED_PAUSE_FEATURE
 #if ENABLED(ADVANCED_PAUSE_FEATURE)
   #define PAUSE_PARK_RETRACT_FEEDRATE         10  // (mm/s) Initial retract feedrate.
   #define PAUSE_PARK_RETRACT_LENGTH            2  // (mm) Initial retract.